Removable Hard Disk Assembly Removal; Tools Required; Removal Procedure - Agilent Technologies E5071C Service Manual

Ena rf network analyzers

Hide thumbs Also See for E5071C:

Table of Contents

Replacement Procedure

Removable Hard Disk Assembly Removal

TORX screwdriver, T10, T15, and T20

Flat edge screwdriver

Refer to Figure 6-3 for this procedure.

Step 1. Remove the outer cover as described in "Outer Cover Removal" on page 266.

Step 2. Remove the front panel as described in "Front Panel Removal" on page 267.

Step 3. Disconnect the two cables (item 1).

Step 4. Remove the three TORX T10 screws (item 2) fastening the removable hard disk assembly.

Step 5. Be careful to release the hook from chassis (item3) and lift the removable hard disk

Step 6. Remove the four TORX T10 screws (item 4) fastening the bracket.