Control Touch Panel Replacement; Tools Required; Removal Procedure; Replacement Procedure - Agilent Technologies E5071C Service Manual

Ena rf network analyzers

Hide thumbs Also See for E5071C:

Table of Contents

Control Touch Panel Replacement

TORX screwdriver, T10, T15, and T20

Flat edge screwdriver

Refer to Figure 6-28 for this procedure.

Step 1. Remove the outer cover as described in "Outer Cover Removal" on page 266.

Step 2. Remove the front panel as described in "Front Panel Removal" on page 267.

Step 3. Disconnect the cables (item 1, 2) connected through the cover.

Step 4. Remove the two TORX T10 screws (item 3) fastening the control touch panel.

Control Touch Panel Replacement

e5071cse1166

Step 1. Replace the control touch panel by inverse procedure of removal.

Replacement Procedure

Control Touch Panel Replacement