Receiver Module Replacement For 4-Port Model; Tools Required; Removal Procedure - Agilent Technologies E5071C Service Manual

Replacement Procedure

Receiver Module Replacement for 4-Port model

Receiver Module Replacement for 4-Port model

Tools Required

• TORX screwdriver, T10, T15, and T20
• Flat edge screwdriver
• Open-end wrench, 5/8 inch
• Open-end torque wrench, 5/16 inch (set to 1.08 N-m / 9.5 lb-in) (for reconnecting SMA
connector)
• Torque driver set, 5/16 inch (set to 1.08 N-m / 9.5 lb-in) (for reconnecting SMA
connector)

Removal Procedure

Refer to Figure 6-18 for this procedure.
Step 1. Remove the outer cover as described in "Outer Cover Removal" on page 266.
Step 2. Remove the front panel as described in "Front Panel Removal" on page 267.
Step 3. Disconnect the two semi-rigid cable (item 1).
Step 4. Disconnect the two semi-rigid cable (item 2).
Step 5. Disconnect the four semi-rigid cables (item 3).
Step 6. Remove the four TORX T10 screws fastening the module to the bottom. (item 4)
Step 7. Slide the receiver module (item 5).
302 Chapter 6