Restore Backup Files Onto The New Hard Disk Drive; Calibration Of The Touch Screen - Agilent Technologies E5071C Service Manual

Replacement Procedure
Removable Hard Disk Drive Replacement

Restore Backup Files onto the New Hard Disk Drive

The following procedure shows how to write the system correction data stored in the
backup memory to the newly mounted hard disk.
Step 1. Turn on the E5071C.
Step 1. Press
Step 2. Click
Step 3. Select
Open
Step 1. Press
Step 2. The RestoreSysCorFile dialog box appears.
Step 3. Click
NOTE Once the program has terminated, restart the E5071C to enable the system correction data.

Calibration of the Touch Screen

When you have replaced the HDD on a E5071C equipped, you have to calibrate the touch
screen. Follow the procedure described below to calibrate the touch screen.
Step 1. Press
Step 2. Press
Step 3. Press
Step 4. Press
The touch screen calibration screen (Figure 6-3) appears.
272
.
in the softkey menu.
Load Project...
RestoreSysCorFile.vba
button.
.
.
OK
.
.
Service Menu
.
Test Menu
.
Adjust Touch Screen
from the
D:\Agilent\Service
folder and then press the
Chapter 6