Hard Disk Drive Replacement Option 019; Tools Required; Removal Procedure - Agilent Technologies E5071C Service Manual

Ena rf network analyzers

Hide thumbs Also See for E5071C:

Table of Contents

Hard Disk Drive Replacement Option 019

TORX screwdriver, T10

Torque screwdriver, TORX T10 (set to 0.50 N-m / 4.4 lb-in)

Refer to Figure 6-9 for this procedure.

Step 1. Remove the outer cover as described in "Outer Cover Removal" on page 266.

Step 2. Disconnect the two cables (item 1).

Step 3. Remove the four TORX T10 screws (item 2) fastening the hard disk assembly.

Step 4. Remove the four TORX T10 screws (item 3) fastening the hard disk bracket.

Step 5. Remove the hard disk drive (item 4) from the connector board.

Replacement Procedure

Hard Disk Drive Replacement Option 019