Synthesizer Module Replacement; Tools Required; Removal Procedure - Agilent Technologies E5071C Service Manual
Ena rf network analyzers
Hide thumbs
Also See for E5071C:
- Manual (2685 pages) ,
- Compliance tests (45 pages) ,
- Configuration manual (18 pages)
Table of Contents
Advertisement
Replacement Procedure
Synthesizer Module Replacement
Synthesizer Module Replacement
Tools Required
•
TORX screwdriver, T10, T15, and T20
•
Flat edge screwdriver
•
Open-end wrench, 5/8 inch
•
Open-end torque wrench, 5/16 inch (set to 1.08 N-m / 9.5 lb-in) (for reconnecting SMA
connector)
•
Torque driver set, 5/16 inch (set to 1.08 N-m / 9.5 lb-in) (for reconnecting SMA
connector)
Removal Procedure
Refer to Figure 6-18 for this procedure.
Step 1. Remove the outer cover as described in "Outer Cover Removal" on page 266.
Step 2. Remove the front panel as described in "Front Panel Removal" on page 267.
Step 3. Disconnect the semi-rigid cable (item 1).
Step 4. Disconnect the semi-rigid cable (item 2).
Step 5. Remove the two TORX T10 screws fastening the module to the bottom. (item 3)
Step 6. Slide the synthesizer module (item 4).
298
Chapter 6
Advertisement
Table of Contents
Troubleshooting
