Standard Display Mode - ABB DriveIT ACH550-01 User Manual

Standard display mode

Use the standard display mode to read information on the drive's
status and to operate the drive. To reach the standard display
mode, press EXIT until the LCD display shows status
information as described below.
Status information
Top. The top line of the LCD display shows the basic status
information of the drive.
• HAND - Indicates that the drive control is local, i.e., from the
control panel.
• AUTO - Indicates that the drive control is remote, such as the
basic I/O (X1) or fieldbus.
• - Indicates the drive and motor rotation status as
follows:
Control panel display
Rotating arrow (clockwise or
counterclockwise)
Rotating arrow blinking
Stationary arrow
• Upper right - shows the active reference.
Middle. Using parameter group 34,
the middle of the LCD display can be
configured to display:
• 3 parameter values - The default
display shows parameters 0103
(OUTPUT FREQ) in percentages,
0104 (CURRENT) in amperes and 0120 (AI1) in
milliamperes.
• A bar meter rather than one of the
parameter values.
Bottom. The bottom of the LCD
display shows:
• Lower corners - show the
functions currently assigned to the two soft keys.
64
ACH550 User's Manual
Significance
• Drive is running and at
setpoint
• Shaft direction is forward
or reverse
Drive is running but not at
setpoint
Drive is stopped
Start-up & control panel