Installing The Drive; What This Chapter Contains; Preparing The Mounting Location - ABB DriveIT ACH550-01 User Manual

Hide thumbs Also See for DriveIT ACH550-01:

Table of Contents

ACH550 User's Manual

Installing the drive

This chapter contains the mechanical and electrical installation

procedure of the drive.

Warning! Before installing the ACH550, ensure the input power

supply to the drive is off.

Note! The ACH550 should only be mounted where all of the

requirements defined in "Preparing for installation" are met and

the checklist has been completed.

Use the Mounting

template to mark the

position of the mounting

Drill the holes.

Insert the screws halfway

into the holes.

Note! Frame sizes R3 and R4 have four holes along the top.

Use only two. If possible, use the two outside holes (to allow

room to remove the fan for maintenance).

Installing the drive

Driveit ach550-uh