ABB DriveIT ACH550-01 User Manual page 73

ACH550 User's Manual
The Start-up assistant is divided into tasks. You may activate the
tasks one after the other, as the Start-up assistant suggests, or
independently.
Note! If you want to set the parameters independently, use the
Parameters mode.
The order of tasks presented by the Start-up assistant depends
on your entries. The following task list is typical.
Task name
Spin the motor
Commission drive
Application
References 1 & 2
Start/Stop Control
Protections
Constant Speeds
PID Control
Start-up & control panel
Description
• Prompts for control panel display language
selection
• Prompts for motor data
• Guides user through rotation check
Prompts for motor data
Prompts for application macro selection
• Prompts for the source of speed references 1
and 2
• Prompts for reference limits
• Prompts for frequency (or speed) limits
• Prompts for the source for start and stop
commands
• Prompts for start and stop mode definition
• Prompts for acceleration and deceleration
times
• Prompts for current and torque limits
• Prompts for the use of Run enable and Start
enable signals
• Prompts for the use of emergency stop
• Prompts for Fault function selection
• Prompts for Auto reset functions selection
• Prompts for the use of constant speeds
• Prompts for constant speed values
• Prompts for PID settings
• Prompts for the source of process reference
• Prompts for reference limits
• Prompts for source, limits and units for the
process actual value
• Defines the use of Sleep function
69