ABB DriveIT ACH550-01 User Manual page 250

Code Description
3105 AR OVERVOLTAGE
Sets the automatic reset for the overvoltage 1=ENABLE
function on or off.
0 =
DISABLE
1 =
ENABLE
• Automatically resets the fault (
3103
3106 AR UNDERVOLTAGE
Sets the automatic reset for the
undervoltage function on or off.
0 =
DISABLE
1 =
ENABLE
• Automatically resets the fault (
set by 3103
3107 AR AI<MIN
Sets the automatic reset for the analog
input less than minimum value function on or off.
0 =
DISABLE
1 =
ENABLE
• Automatically resets the fault (
DELAY TIME
Warning! When the analog input signal is restored, the drive may
restart, even after a long stop. Make sure that automatic, long
delayed starts will not cause physical injury and/or damage
equipment.
3108 AR EXTERNAL FAULT
Sets the automatic reset for external
faults function on or off.
0 =
DISABLE
1 =
ENABLE
• Automatically resets the fault (
FAULT
resumes normal operation.
246
– Disables automatic reset.
– Enables automatic reset.
, and the drive resumes normal operation.
DELAY TIME
– Disables automatic reset.
– Enables automatic reset.
DELAY TIME
– Disables automatic reset.
– Enables automatic reset.
, and the drive resumes normal operation.
– Disables automatic reset.
– Enables automatic reset.
2) after the delay set by 3103
ACH550 User's Manual
0=DISABLE,
DC OVERVOLT
0=ENABLE,
1=DISABLE
DC UNDERVOLTAGE
, and the drive resumes normal operation.
< ) after the delay set by 3103
AI MIN
0=DISABLE,
EXTERNAL FAULT
DELAY TIME
Parameter listing and descriptions
Range
) after the delay set by
) after the delay
0=DISABLE,
1=ENABLE
1=ENABLE
1 or
EXTERNAL
, and the drive