ABB DriveIT ACH550-01 User Manual page 294

Code Description
5307 EFB CRC ERRORS
Contains a count of the messages with a CRC error received by
the drive. For high counts, check:
• Ambient electro-magnetic noise levels – high noise levels
generate errors.
• CRC calculations for possible errors.
5308 EFB UART ERRORS
Contains a count of the messages with a character error received
by the drive.
5309 EFB STATUS
Contains the status of the EFB protocol.
0 =
IDLE
messages.
1 =
EXEC
2 =
TIME OUT
between the network master and the EFB protocol.
3 =
CONFIG ERROR
4 =
OFF
addressed to this drive.
5 =
ON
adressed to this drive.
6 =
RESET
7 =
LISTEN ONLY
5310 EFB PAR 10
Specifies the parameter mapped to Modbus Register 40005.
5311 EFB PAR 11
Specifies the parameter mapped to Modbus Register 40006.
5312 EFB PAR 12
Specifies the parameter mapped to Modbus Register 40007.
5313 EFB PAR 13
Specifies the parameter mapped to Modbus Register 40008.
5314 EFB PAR 14
Specifies the parameter mapped to Modbus Register 40009.
5315 EFB PAR 15
Specifies the parameter mapped to Modbus Register 40010.
5316 EFB PAR 16
Specifies the parameter mapped to Modbus Register 40011.
5317 EFB PAR 17
Specifies the parameter mapped to Modbus Register 40012.
290
– EFB protocol is configured, but not receiving any
. – EFB protocol is initializing.
INIT
– A timeout has occurred in the communication
– EFB protocol has a configuration error.
- – EFB protocol is receiving messages that are NOT
LINE
- – EFB protocol is receiving messages that are
LINE
– EFB protocol is performing a hardware reset.
– EFB protocol is in listen-only mode.
ACH550 User's Manual
Range
0...65535
0...65535
0...7
0...65535
0...65535
0...65535
0...65535
0...65535
0...65535
0...65535
0...65535
Parameter listing and descriptions