ABB DriveIT ACH550-01 User Manual page 213

ACH550 User's Manual
Code Description
1606 LOCAL LOCK
Defines control for the use of the HAND mode. The HAND mode
allows drive control from the control panel.
• When
LOCAL LOCK
HAND mode.
0 =
NOT SEL
and control the drive.
1 = 1 – Defines digital input
DI
lock.
• Activating the digital input locks out local control.
• De-activating the digital input enable the HAND selection.
2...6 = 2...
DI
setting the local lock.
• See 1 above.
DI
7 = – Sets the lock. The control panel cannot select HAND, and
ON
cannot control the drive.
8 = – Defines bit 14 of the Command Word 1 as the control for
COMM
setting the local lock.
• The Command Word is supplied through fieldbus communication.
• The Command Word is 0301.
-1 = 1(
DI INV
setting the local lock.
• De-activating the digital input locks out local control.
• Activating the digital input enable the HAND selection.
-2...-6 =
DI
as the control for setting the local lock.
• See 1(
DI
1607 PARAM. SAVE
Saves all altered parameters to permanent memory.
• Parameters altered through a fieldbus are not automatically saved
to permanent memory. To save, you must use this parameter.
• If 1602
PARAMETER LOCK
the control panel are not saved. To save, you must use this
parameter.
• If 1602
PARAMETER LOCK
control panel are stored immediately to permanent memory.
0 = – Value changes automatically when all parameters are
DONE
saved.
1 = – Saves altered parameters to permanent memory.
SAVE
Parameter listing and descriptions
is active, the control panel cannot change to
– Disables the lock. The control panel can select HAND
DI
6 – Defines digital input
DI
) – Defines an inverted digital input
2( )... 6( ) – Defines an inverted digital input
INV DI INV
) above.
INV
= 2 (
= 1 (
Range
0...8, -1...-6
1 as the control for setting the local
2... 6 as the control for
DI DI
1 as the control for
DI
0=DONE, 1=SAVE
), parameters altered from
NOT SAVED
), parameters altered from the
OPEN
2... 6
DI DI
209