ABB DriveIT ACH550-01 User Manual page 241

ACH550 User's Manual
Group 29: Maintenance Trig
This group contains usage levels and trigger points. When
usage reaches the set trigger point, a notice displayed on the
control panel signals that maintenance is due.
Code Description
2901 COOLING FAN TRIG
Sets the trigger point for the drive's cooling fan counter.
• 0.0 =
NOT SEL
2902 COOLING FAN ACT
Defines the actual value of the drive's cooling fan counter.
• The parameter is reset by writing 0.0 to it.
2903 REVOLUTION TRIG
Sets the trigger point for the motor's accumulated revolutions
counter.
• 0.0 =
NOT SEL
2904 REVOLUTION ACT
Defines the actual value of the motor's accumulated revolutions
counter.
• The parameter is reset by writing 0 to it.
2905 RUN TIME TRIG
Sets the trigger point for the drive's run time counter.
• 0.0 =
NOT SEL
2906 RUN TIME ACT
Defines the actual value of the drive's run time counter.
• The parameter is reset by writing 0.0 to it.
2907 USER MWh TRIG
Sets the trigger point for the drive's accumulated power
consumption (in megawatt hours) counter.
• 0.0 =
NOT SEL
2908 USER MWh ACT
Defines the actual value of the drive's accumulated power
consumption (in megawatt hours) counter.
• The parameter is reset by writing 0.0 to it.
Parameter listing and descriptions 237