Use Of Warnings And Notes - ABB DriveIT ACH550-01 User Manual

Use of warnings and notes

There are two types of safety instructions throughout this
manual:
• Warnings caution you about conditions which can result in
serious injury and death and/or damage to the equipment.
They also tell you how to avoid the danger.
• Notes draw attention to a particular condition or fact, or give
information on a subject.The warning symbols are used as
follows:
Dangerous voltage warning warns of high voltage which may
cause physical injury and/or damage to the equipment.
General warning warns about conditions, other than those
caused by electricity, which can result in physical injury and/or
damage to the equipment.
Warning! The ACH550 adjustable speed AC drive should ONLY
be installed by a qualified technician.
Warning! Even when the motor is stopped, dangerous voltage
is present at the Power Circuit terminals U1, V1, W1 and U2, V2,
W2, and, depending on the frame size, UDC+ and UDC-.
Warning! Dangerous voltage is present when input power is
connected. After disconnecting the supply, wait at least 5
minutes before removing the cover. To check, measure for zero
voltage at the DC terminals, which are, depending on the frame
size, UDC+ and UDC-.
Warning! Even when the power is switched off from the input
terminals of the ACH550, there may be dangerous voltage (from
external sources) on the terminals of the relay outputs
R01...R03.
8
ACH550 User's Manual
Contents of this manual