Cabling Instructions; Motor Cables - ABB DriveIT ACH550-01 User Manual

Hide thumbs Also See for DriveIT ACH550-01:

Table of Contents

Cabling instructions

Keep individual unscreened wires between the cable clamps

and the screw terminals as short as possible. Route control

cables away from power cables.

The cabling must comply with EN61800-3, First Environment,

Restricted Distribution, and AS/NZS 2064, 1997, Class A

requirements.

The following figure shows the minimum requirements for the

motor cable screen.

Galvanized steel or tinned copper wire with

braided shield.

Layer of copper tape with concentric layer

of copper wire.

Concentric layer of copper wire with an open helix

of copper tape.

ACH550 User's Manual

Preparing for installation

Driveit ach550-uh