ABB DriveIT ACH550-01 User Manual page 204

Code Description
14 =
AT SET POINT
equal to the reference frequency.
15 =
FAULT
and will reset after the programmed auto-reset delay.
• See parameter 3103 delay time.
16 = /
FLT
17 =
EXT CTRL
18 =
REF
19 =
CONST FREQ
20 =
REF LOSS
is lost.
21 =
OVERCURRENT
fault occurs.
22 =
OVERVOLTAGE
fault occurs.
23 =
DRIVE TEMP
alarm or fault occurs.
24 =
UNDERVOLTAGE
fault occurs.
25 = 1
AI
26 = 2
AI
27 =
MOTOR TEMP
alarm or fault occurs.
28 =
STALL
29 =
UNDERLOAD
occurs.
30 =
PID SLEEP
31 = PFA – Use relay to start/stop motor in PFA control (See Group
81: PFA Control).
• Use this option only when PFA control is used.
• Selection activated / deactivated when drive is not running.
32 =
AUTOCHANGE
is performed.
• Use this option only when PFA control is used.
33 =
FLUX READY
able to supply nominal torque (motor has reached nominal
magnetizing).
34 =
USER S
200
– Energize relay when the output frequency is
( ) – Energize relay when the drive is in a fault condition
RST
– Energize relay when fault or alarm occurs.
ALARM
– Energize relay when external control is selected.
2 – Energize relay when
SEL
– Energize relay when a constant speed is selected.
– Energize relay when reference or active control place
– Energize relay when an overcurrent alarm or
– Energize relay when an overvoltage alarm or
– Energize relay when a drive overtemperature
– Energize relay when an undervoltage alarm or
– Energize relay when
LOSS
– Energize relay when
LOSS
– Energize relay when a motor overtemperature
– Energize relay when a stall alarm or fault exists.
– Energize relay when an underload alarm or fault
– Energize relay when the PID sleep function is active.
– Energize relay when PFA autochange operation
– Energize relay when the motor is magnetized and
2 – Energize relay when User Parameter Set 2 is active.
ACH550 User's Manual
Range
2 is selected.
EXT
1 signal is lost.
AI
2 signal is lost.
AI
Parameter listing and descriptions