Drive Control Parameters - ABB DriveIT ACH550-01 User Manual

Code Description
5131 FBA STATUS
Contains the status of the adapter module.
0 =
IDLE
1 =
EXEC
2 =
TIME OUT
between the adapter and the drive.
3 =
CONFIG ERROR
minor revision code of the adapter's CPI firmware revision
differs from that stated in the drive's configuration file.
4 =
OFF
5 = -
ON
6 =
RESET
5132 FBA CPI FW REV
Contains the revision of the module's CPI program. Format is xyz
where:
• x = major revision number
• y = minor revision number
• z = correction number
Example: 107 = revision 1.07
5133 FBA APPL FW REV
Contains the revision of the module's application program Format
is xyz where:
• x = major revision number
• y = minor revision number
• z = correction number
Example: 107 = revision 1.07
The new settings will take effect when the drive is next powered
up, or when parameter 51.27 is activated.

Drive control parameters

After the fieldbus communication has been set up, the drive
control parameters listed in the tables below should be checked
and adjusted where necessary.
The "Setting for fieldbus control & Description column" gives the
value to use when the fieldbus interface is the desired source or
destination for that particular signal and a description of the
parameter.
The fieldbus signal routes and message composition are
explained later in the section "Fieldbus control interface".
136
– Adapter not configured.
. – Adapter is initializing.
INIT
– A time-out has occurred in the communication
– Adapter configuration error. The major or
- – Adapter is off-line.
LINE
– Adapter is on-line.
LINE
– Adapter is performing a hardware reset.
ACH550 User's Manual
Range
0...6
0...0xFFFF
0...0xFFFF
Serial communications