ABB DriveIT ACH550-01 User Manual page 212

Code Description
1605 USER PAR SET CHG
Defines control for changing the user parameter set.
• See parameter 9902 (
• The drive must be stopped to change User Parameter Sets.
• During a change, the drive will not start.
Note: Always save the User Parameter Set after changing any
parameter settings, or performing a motor identification.
• Whenever the power is cycled, or parameter 9902 (
is changed, the drive loads the last settings saved. Any unsaved
changes to a user parameter set are lost.
Note: The value of this parameter (1605) is not included in the User
Parameter Sets, and does not change if User Parameter Sets
change.
Note: You can use a relay output to supervise the selection of User
Parameter Set 2.
• See parameter 1401.
0 =
NOT SEL
the only control for changing User Parameter Sets.
1 = 1 – Defines digital input
DI
Parameter Sets.
• The drive loads User Parameter Set 1 on the falling edge of the
digital input.
• The drive loads User Parameter Set 2 on the rising edge of the
digital input.
• The User Parameter Set changes only when the drive is stopped.
2...6 =
DI
changing User Parameter Sets.
• See
-1 = 1(
DI
changing User Parameter Sets.
• The drive loads User Parameter Set 1 on the rising edge of the
digital input.
• The drive loads User Parameter Set 2 on the falling edge of the
digital input.
• The User Parameter Set changes only when the drive is stopped.
-2...-6 =
as a control for changing User Parameter Sets.
• See
208
APPLIC MACRO
– Defines the control panel (using parameter 9902) as
2... 6 – Defines digital input
DI
1 above.
DI
) – Defines an inverted digital input
INV
2( )... 6( ) – Defines an inverted digital input
DI INV DI INV
1( ) above.
DI INV
ACH550 User's Manual
Range
0...6, -1...-6
).
1 as a control for changing User
DI
2... 6 as a control for
DI DI
DI
Parameter listing and descriptions
APPLIC MACRO
1 as a control for
2...
DI DI
)
6