ABB DriveIT ACH550-01 User Manual page 49

ACH550 User's Manual
2. On the input power cable, strip the sheathing back far
enough to route individual wires. Also strip the individual
wires
5
2
4
3. On the motor cable, strip the sheathing back far enough to
expose the copper wire screen so that the screen can be
twisted into a pigtail.Keep the pigtail short to minimize noise
radiation. Also strip the individual wires.
4. Route the power and motor cables through the clamps and
tighten the clamps. On the motor cable, check for 360
contact between the cable shield and the clamp.
5. Connect the power/motor wires, and the ground wires to the
drive terminals.
Note! Check the cable lengths according to the table in"Wiring
and EMC considerations".
Installing the drive
3
4
º
45