ABB DriveIT ACH550-01 User Manual page 289

ACH550 User's Manual
Group 51: Ext Comm Module
This group defines set-up variables for an external fieldbus
communication module. Refer to communication module
documentation for more information on these parameters.
Code Description
5101 FBA TYPE
Displays the type of the connected fieldbus adapter module.
0 = Module not found or not connected. Check the fieldbus User's
Manual chapter "Mechanical Installation" and check that
parameter 9802 is set to 4 = EXT FBA.
1 =
PROFIBUS
16 =
INTERBUS
21 =
LONWORKS
32 =
CANOPEN
37 =
DEVICENET
64 =
MODBUS PLUS
101 =
CONTROLNET
128 =
ETHERNET
5102... FB PAR 2...FB PAR 26
5126
Refer to communication module documentation for more
information on these parameters.
5127 FBA PAR REFRESH
Validates any changed fieldbus parameter settings.
• After refreshing, the value reverts automatically to DONE.
5128 FILE CPI FW REV
Displays the CPI firmware revision of the drive's fieldbus adapter
configuration file. Format is xyz where:
• x = major revision number
• y = minor revision number
• z = correction number
Example: 107 = revision 1.07
5129 FILE CONFIG ID
Displays the revision of the drive's fieldbus adapter module's
configuration file identification.
• File configuration information is drive application program-
dependent.
5130 FILE CONFIG REV
Contains the revision of the drive's fieldbus adapter module
configuration file.
Example: 1 = revision 1
Parameter listing and descriptions
- –
DP
–
–
–
–
–
–
–
Range
0...65535
0=DONE, 1=REFRESH
0...0xFFFF
0...0xFFFF
0...0xFFFF
285