HEIDENHAIN TNC 620 User Manual page 63

First steps | Programming the first part
Retract the tool
Press the L key
Press the Z axis key
Enter the retraction value (e.g., 250 mm)
Press the ENT key
At radius compensation, press ENT
The control applies R0.
At feed rate F, press the ENT key
The control applies FMAX.
Enter a miscellaneous function M, such as M30
for program end
Press the END key
The control saves the positioning block and ends
the NC program.
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022
2
63