Selecting A Point Table In The Nc Program - HEIDENHAIN TNC 620 User Manual

8

Selecting a point table in the NC program

To select a point table in your NC program:
In the Programming operating mode, select the NC program for
which you want to activate the point table.
Press the PGM CALL key
Press the SELECT POINT TABLE soft key
Press the SELECT FILE soft key
Select the point table from the folder structure
Press the OK soft key
If the point table is not stored in the same directory as the NC
program, you must enter the complete path.
If the called file is located in the same directory as the
file you are calling it from, you can also integrate the file
name without the path. The APPLY FILE NAME soft key
provided in the selection window of the SELECT FILE soft
key is available for this.
Example
7 SEL PATTERN "TNC:\nc_prog\Positions.PNT"
256
Subprograms and program section repeats | Point tables
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022