Editing A Job List - HEIDENHAIN TNC 620 User Manual

13

Editing a job list

You can edit a job list in the Programming, Program run, single
block, and Program run, full sequence operating modes.
Operating notes:
If a job list is selected in the Program run, single
block or Program run, full sequence operating
mode, it is not possible to edit the job list in the
Programming operating mode.
The possibilities of changing a job list during
machining are limited, because the control defines a
protected area.
NC programs in the protected area are shown in light
gray.
To edit a line in the job list in Batch Process Manager:
Open the desired job list
Press the EDIT soft key
Place the cursor on the desired line (e.g., Pallet)
The control displays the selected line in blue.
The control displays the editable entries on the
right-hand side.
Press the CHANGE WINDOW soft key if required
The control switches the active window.
The following entries can be changed:
Confirm the edited entries by pressing the ENT
key.
The control adopts the changes.
Press the EDIT soft key
532
Name
Datum table
Preset
Locked
Machinable
Pallets | Batch Process Manager (option 154)
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022