Special functions | Working with the parallel axes U, V and W
Deactivating FUNCTION PARAXMODE
After the control has booted, the configuration defined by
the machine tool builder is in effect.
Check whether one of the icons for PARAXCOMP
DISPLAY or PARAXCOMP MOVE is shown in the status
display:
or
The control resets the PARAXMODE ON parallel-axis
function via the following functions:
Selection of NC program
End of program
M2 and M30
PARAXMODE OFF
You must deactivate the parallel-axis functions before
switching the machine kinematics.
Use the PARAXCOMP OFF function to switch off the parallel-axis
function. The control then uses the principal axes defined by the
machine tool builder.
Proceed as follows for the definition:
Show the soft-key row with special functions
Press the PROGRAM FUNCTIONS soft key
Press the FUNCTION PARAX soft key
Press the FUNCTION PARAXMODE soft key
Select FUNCTION PARAXMODE OFF
Example
13 FUNCTION PARAXMODE OFF
When FUNCTION PARAXMODE is not active, the control does not
display the corresponding icon or entries on the POS tab.
Depending on the configuration by the machine tool
builder, an active PARAXCOMP icon that was previously
hidden by the PARAXMODE icon will then become visible.
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022
10
371