Copying A Preset - HEIDENHAIN TNC 620 User Manual

10

Copying a preset

The function PRESET COPY allows you to copy a preset defined in
the preset table and activate the preset copied.
To select the preset to be copied, use the preset number or the entry
in the Doc column. If the entry in the Doc column is not unique, the
control will select the preset with the smallest preset number.
Use the optional parameters to define the following:
SELECT TARGET: Activate the copied preset
KEEP TRANS: Retain simple transformations
Procedure
Proceed as follows for the definition:
Press the SPEC FCT key
Press the PROGRAM DEFAULTS soft key
Press the PRESET soft key
Press the PRESET COPY soft key
Define the preset number to be copied
As an alternative, define the entry from the Doc
column
Define the new preset number
Activate the copied preset, if necessary
Retain the transformations where necessary
Example
13 PRESET COPY #1 TO #3 SELECT TARGET KEEP TRANS
392
Special functions | Modifying presets
Copy the preset 1 to line 3, activate the preset 3, and retain the
transformations
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022