HEIDENHAIN TNC 620 User Manual page 583

Tables and overviews | System data
Group Group number
name ID...
Activate machine parameter subfile
1020
Configuration settings for cycles
1030
Data transfer between HEIDENHAIN cycles and OEM macros
1031
User settings for the user interface
1070
Bit test
2300
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022
System data Index IDX...
number NO....
13 QS parameter
no.
1 -
-
1 0
1
2
3 – 9
100 -
1 -
Number Bit number
Description
Has a machine parameter subfile with path
from QS number (IDX) been loaded?
1 = Yes
0 = No
Display the Spindle does not rotate error
message?
(CfgGeoCycle/displaySpindleErr)
0 = no, 1 = yes
Display the Check the algebraic sign for
depth! error message?
(CfgGeoCycle/displayDepthErr)
0 = no, 1 = yes
Component monitoring: counter of the
measurement. Cycle 238 Measure machine
data automatically increments this counter.
Component monitoring: Type of measurement
–1 = No measurement. Writing of the value
with FN17 concludes Cycle 238.
0 = Circular test
1 = Waterfall diagram
2 = Frequency response
3 = Envelope curve spectrum
Component Monitoring: Index of the axis from
CfgAxes\MP_axisList
Component monitoring: further arguments
depend on the measurement
Component monitoring: optional names of
the monitoring tasks, as specified in System
\Monitoring\CfgMonComponent. After
completion of the measurement, the monitor-
ing tasks stated here are executed consecu-
tively. When assigning the input parameters,
remember to separate the listed monitoring
tasks by commas.
Feed rate limit of soft key FMAX; 0 = FMAX is
inactive
This function checks whether a bit has been
set in a number. The number to be checked
is transferred as NR, the bit to be searched
for as IDX, with IDX0 designating the least
significant bit. To call this function for large
numbers, make sure to transfer NR as a Q
15
583