HEIDENHAIN TNC 620 User Manual page 587

Tables and overviews | System data
No. IDX
33 Tool no.
ID 51 Data from the pocket table
6 Pocket no.
7 Pocket no.
8 Pocket no.
9 Pocket no.
10 Pocket no.
11 Pocket no.
12 Pocket no.
13 Pocket no.
14 Pocket no.
15 Pocket no.
16 Pocket no.
ID 56 File information
1 -
2 -
3 Q parameters
4 -
ID 214 Current contour data
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
ID 240 Nominal positions in the REF system
8 -
ID 280 Information on M128
2 -
ID 290 Switch the kinematics
1 -
2 Bit no.
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022
Contents
Thread pitch (Pitch)
Tool type
P1
P2
P3
P4
P5
Pocket reserved
0 = No, 1 = Yes
Box magazine: Pocket above occupied: 0 =
No, 1 = Yes
Box magazine: Pocket below occupied: 0 =
No, 1 = Yes
Box magazine: Pocket to the left occupied:
0 = No, 1 = Yes
Box magazine: Pocket to the right occupied:
0 = No, 1 = Yes
Number of lines of the tool table
Number of lines of the active datum table
Number of active axes that are
programmed in the active datum table
Number of lines in a freely definable table
that has been opened with FN 26: TABOPEN
Contour transition mode
Max. linearization error
Mode for M112
Character mode
Mode for M124
Specification for contour pocket machining
Filter for control loop
Tolerance programmed with Cycle 32
ACTUAL position in the REF system
Feed rate that was programmed with M128
Line of the active kinematics table
Interrogate the bits in MP7500
Replacement function
ID 50 NR 40
2)
2)
2)
2)
2)
2)
2)
2)
2)
2)
2)
1)
ID 30 no. 48
ID 280 NR 3
SYSSTRING 10290
Cfgread
15
587