Special functions | Modifying presets
Correcting a preset
The function PRESET CORR allows you to correct the active preset.
If both the basic rotation and a translation are corrected in an NC
block, the control will first correct the translation and then the basic
rotation.
The compensation values are given with respect to the active
coordinate system.
Procedure
Proceed as follows for the definition:
Show the soft key row with special functions
Press the PROGRAM DEFAULTS soft key
Press the PRESET soft key
Press the PRESET CORR soft key
Define the desired compensation values
Example
13 PRESET CORR X+10 SPC+45
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022
The active preset is corrected by a value of +10 mm in X, and
by +45° in SPC
10
393