9
Activating FN 16 output in an NC program
Within the FN 16 function, you specify the output file that contains
the texts to be output.
The control displays the output file in the following cases:
End of program END PGM
Cancellation of program with the NC STOP key
M_CLOSE command
Enter the path to the text file and the path to the output file in the
FN 16 function.
Proceed as follows:
Press the Q key.
Press the DIVERSE FUNCTION soft key
Press the FN16 F-PRINT soft key
Press the SELECT FILE soft key
Select the source, i.e. the text file in which the
output file is defined
Confirm with the ENT key
Select the target, i.e. the output path
There are two ways to define the output path:
Directly in the FN 16 function
In the machine parameters, under CfgUserPath (no. 102200)
If the called file is located in the same directory as the
file you are calling it from, you can also integrate the file
name without the path. The APPLY FILE NAME soft key
provided in the selection window of the SELECT FILE soft
key is available for this.
302
Programming Q parameters | Additional functions
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022