HEIDENHAIN TNC 620 User Manual page 43

Basic information | Control model, software and features
Changed functions 81760x-16
In order for the control to show the workpiece blank in the
simulation, the workpiece blank must have minimum dimensions.
The minimum dimensions are 0.1 mm or 0.004 inches in all axes
as well as in the radius.
Further information: "Defining the workpiece blank: BLK FORM",
Page 91
The pop-up window for tool selection always shows the content
of the NAME column, even if you are calling the tool with the tool
number.
Further information: "Calling the tool data", Page 128
Within FUNCTION S-PULSE, you can define a lower and an upper
speed limit for the pulsing speed by means of the FROM-SPEED
and TO-SPEED syntax elements.
Further information: "Pulsing spindle speed FUNCTION S-
PULSE", Page 419
In the OPEN FILE function, the control opens files automatically
with the software tool that was used last for this file type.
Further information: "OPEN FILE", Page 381
While program run is interrupted or has been canceled, you can
edit Q and QS parameters with numbers 0 to 99, 200 to 1199 and
1400 to 1999 in the Q parameter list window.
Further information: "Checking and changing Q parameters",
Page 288
The result fields and the diameter field of the cutting data
calculator are freely editable.
Further information: "Cutting data calculator", Page 203
Further information: User's Manual for Setup, Testing and Running
NC Programs
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022
1
43