Programming aids | Error messages
Deleting errors
The control can automatically clear pending warning
or error messages when an NC program is selected
or restarted. The machine tool builder specifies in the
optional machine parameter CfgClearError (no. 130200)
whether these messages will automatically be cleared.
The factory default setting of the control defines
that warning and error messages in the Test Run
and Programming operating modes will be cleared
automatically from the error window. Messages issued in
the machine operating modes will not be cleared.
Clearing errors outside of the error window
Press the CE key
The control clears the errors or notes being
displayed in the header.
In certain situations you cannot use the CE key for
clearing the errors because the key is used for other
functions.
Clearing errors
Open the error window
Position the cursor on the corresponding error message
Press the DELETE soft key
As an alternative, clear all errors: Press the
DELETE ALL soft key
If the cause of the error has not been corrected, the
error message cannot be cleared. In this case, the error
message remains in the window.
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022
6
213