14
Operating the simulation
The control offers touch operation with the following graphics:
Programming graphics in the Programming operating mode.
3-D view in the Test Run operating mode.
3-D view in the Program Run Single Block operating mode.
3-D view in the Program Run Full Sequence operating mode.
Kinematics view
Rotating, zooming, or moving a graphic
The control supports the following gestures:
Symbol
Gesture
Double tap
Drag
Two-finger drag
Spread
Pinch
Measuring a graphic
If you have activated measurement in the Test Run operating mode,
the following additional function is available:
Symbol
Gesture
Tap
542
Operating the touchscreen | Gestures
Function
Set the graphic to its original size
Rotate the graphic (only 3-D graphics)
Move graphics
Magnify the graphic
Reduce the graphic
Function
Select the measuring point
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022