HEIDENHAIN TNC 620 User Manual page 25

Contents
11.6 Three-dimensional tool compensation (option 9)........................................................................... 476
Introduction..................................................................................................................................................................476
Suppressing error messages with positive tool oversize: M107..................................................................... 477
Definition of a normalized vector........................................................................................................................... 478
Permissible tool shapes............................................................................................................................................479
Using other tools: Delta values............................................................................................................................... 479
3-D compensation without TCPM.......................................................................................................................... 480
Face Milling: 3D compensation with TCPM......................................................................................................... 481
Peripheral milling: 3-D radius compensation with TCPM and radius compensation (RL/RR)....................483
Interpretation of the programmed path................................................................................................................ 484
11.7 Running CAM programs................................................................................................................. 486
From 3-D model to NC program.............................................................................................................................486
Considerations required for post processor configuration............................................................................... 487
Please note the following for CAM programming.............................................................................................. 489
Possibilities for intervention on the control..........................................................................................................491
ADP motion control....................................................................................................................................................491
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022
25