Special functions | Function mode
10.2 Function mode
Program function mode
Refer to your machine manual.
Your machine manufacturer enables this function.
If your machine manufacturer has enabled the selection of various
kinematic models, then you can switch between them using the
FUNCTION MODE soft key.
Procedure
To switch the kinematic model, proceed as follows:
Show the soft-key row for special functions
Press the FUNCTION MODE soft key
Press the MILL soft key
Press the SELECT KINEMATICS soft key
Select the desired kinematic model
Function Mode Set
Refer to your machine manual.
This function must be enabled and adapted by the
machine manufacturer.
Your machine tool builder defines the available options in
the machine parameter CfgModeSelect (no. 132200).
FUNCTION MODE SET allows you to activate settings defined by the
machine tool builder (e.g., changes to the range of traverse) from
within the NC program
To select a setting:
Show the soft-key row with special functions
Press the FUNCTION MODE soft key
Press the SET soft key
Press the SELECT soft key, if required
The control opens a selection window.
Select the desired setting
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022
10
363