10
Activate the compensation table
Select compensation table
If you are using compensation tables, then use the function SEL
CORR-TABLE to activate the desired compensation table from within
the NC program.
To add a compensation table to the NC program, proceed as
follows:
Press the SPEC FCT key
Press the PROGRAM DEFAULTS soft key
Press the SELECT COMPENS. TABLE soft key
Press the soft key of the table type (e.g., TCS)
Select the table
If you are working without the SEL CORR-TABLE function, then you
must activate the desired table prior to the test run or program run.
In all operating modes, proceed as follows:
Select the desired operating mode
Select the desired table in the file manager
In Test Run mode, the table receives the status S; in the operating
modes Program run, single block and Program run, full
sequence, the table receives the status M.
Activating a compensation value
To activate a compensation value in the NC program, proceed as
follows:
Press the SPEC FCT key
Press the PROGRAM FUNCTIONS soft key
Press the TRANSFORM / CORRDATA soft key
Press the FUNCTION CORRDATA soft key
Press the soft key of the desired compensation
(e.g., TCS)
Enter the line number
Duration of effect of the compensation
The activated compensation stays in effect until the end of the
program or until a tool change occurs.
With FUNCTION CORRDATA RESET, you can program the
compensations to reset.
400
Special functions | Compensation table
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022