Deactivating Function Paraxcomp - HEIDENHAIN TNC 620 User Manual

10

Deactivating FUNCTION PARAXCOMP

After the control has booted, the configuration defined by
the machine tool builder is in effect.
Check whether one of the icons for PARAXCOMP
DISPLAY or PARAXCOMP MOVE is shown in the status
display:
To reset the PARAXCOMP parallel-axis function, proceed
as follows:
Selection of NC program
PARAXCOMP OFF
You must deactivate the parallel-axis functions before
switching the machine kinematics.
Use the PARAXCOMP OFF function to switch off the PARAXCOMP
DISPLAY and PARAXCOMP MOVE parallel-axis functions. Proceed as
follows for the definition:
Show the soft-key row with special functions
Press the PROGRAM FUNCTIONS soft key
Press the FUNCTION PARAX soft key
Press the FUNCTION PARAXCOMP soft key
Select FUNCTION PARAXCOMP OFF
Enter an axis, if required
Example
13 FUNCTION PARAXCOMP OFF
13 FUNCTION PARAXCOMP OFF W
When FUNCTION PARAXCOMP is not active, the control does not
display the corresponding icon and the additional information after
the axis designations.
In a machine parameter, your machine manufacturer can
set the PARAXCOMP function to be active by default.
If you want to switch the function off, you must indicate
the parallel axis in the NC block, for example FUNCTION
PARAXCOMP OFF W.
Further information: "Automatic calculation of the
parallel axes", Page 365
368
or
Special functions | Working with the parallel axes U, V and W
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022