Comparison: Fn 18 Functions - HEIDENHAIN TNC 620 User Manual

15
Group Group number
name ID...
Read information on unbalance cycle (system string)
10855
Read data of the current tool (system string)
10950
Read data from FUNCTION MODE SET (system string)
11031

Comparison: FN 18 functions

The following table lists the FN 18 functions from previous controls,
which were not implemented in this manner in the TNC 620.
In most cases, this function has been replaced by another function.
No.
ID 10 Program information
1
2
4
ID 20 Machine status
15
16
17
19
ID 50 Data from the tool table
23
24
25
26
27
29
30
31
586
System data
number NO....
1
1
2
3
4
5
10
IDX Contents
- mm/inch condition
- Overlap factor for pocket milling
- Number of the active fixed cycle
Log. axis Assignment between logic and geometric
axes
- Feed rate for transition arcs
- Currently selected range of traverse
- Maximum spindle speed for current gear
stage and spindle
Tool no. PLC value
Tool no. Probe center offset in reference axis (CAL-
OF1)
Tool no. Probe center offset in minor axis (CALOF-2)
Tool no. Spindle angle during calibration (CAL-ANG)
Tool no. Tool type for pocket table (PTYP)
Tool no. Position P1
Tool no. Position P2
Tool no. Position P3
Index IDX... Description
- Path of the unbalance calibration table belong-
ing to the active kinematics
- Current tool name
- Entry from the DOC column of the active tool
- AFC control setting
- Tool-carrier kinematics
- Entry from the DR2TABLE column – file
name of the compensation value table for 3D-
ToolComp
- Returns the selection of the FUNCTION MODE
SET <OEM mode> macro as a string.
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022
Tables and overviews | System data
Replacement function
Q113
CfgRead
ID 10 no. 3
SYSTRING 10300
Maximum gear range: ID 90 No.
2
1)
ID 350 NR 53 IDX 1
ID 350 NR 53 IDX 2
ID 350 NR 54
2)
1)
1)
1)