HEIDENHAIN TNC 620 User Manual page 559

Tables and overviews | System data
Group Group number
name ID...
Values for LAC and VSC
71
Freely available memory area for OEM cycles
72
Freely available memory area for user cycles
73
Read minimum and maximum spindle speed
90
Tool compensation
200
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022
System data Index IDX...
number NO....
0 0
2
1 0
0-39 0 to 30
0-39 0 to 30
1 Spindle ID
2 Spindle ID
1 1 = without
oversize 2 =
with oversize 3
= with oversize
Description
Index of the NC axis for which the LAC
weighing run will be performed or was last
performed (X to W = 1 to 9)
Total inertia determined by the LAC weighing
run in [kgm ] (with A/B/C rotary axes) or total
2
mass in [kg] (with X/Y/Z linear axes)
Cycle 957 Retraction from thread
Freely available memory area for OEM cycles.
The values are only reset by the control during
a control reboot (= 0).
With "Cancel," the values are not reset to the
value that they had at the time of execution.
Up to and including 597110-11: only NR 0-9
and IDX 0-9
Starting with 597110-12: NR 0-39 and IDX
0-30
Freely available memory area for user cycles
The values are only reset by the control during
a control reboot (= 0).
With "Cancel," the values are not reset to the
value that they had at the time of execution.
Up to and including 597110-11: only NR 0-9
and IDX 0-9
Starting with 597110-12: NR 0-39 and IDX
0-30
Minimum spindle speed of the lowest gear
stage. If no gear stages are configured,
CfgFeedLimits/minFeed of the first parameter
set of the spindle is evaluated.
Index 99 = active spindle
Maximum spindle speed from the highest
gear stage. If no gear stages are configured,
CfgFeedLimits/maxFeed of the first parame-
ter set of the spindle is evaluated.
Index 99 = active spindle
Active radius
15
559