Calling An External Nc Program - HEIDENHAIN TNC 620 User Manual

8

Calling an external NC program

Calling a program with PGM CALL
You can call an external NC program with the PGM CALL function.
The control runs the external NC program from the position where it
was called in the NC program.
Proceed as follows:
Press the PGM CALL key
Press the CALL PROGRAM soft key
The control starts the dialog for defining the
NC program to be called.
Enter the path name with the keyboard
Alternative:
Press the SELECT FILE soft key
The control displays a selection window in which
you can select the NC program to be called.
Press the ENT key
If the called file is located in the same directory as the
file you are calling it from, you can also integrate the file
name without the path. The APPLY FILE NAME soft key
provided in the selection window of the SELECT FILE soft
key is available for this.
252
Subprograms and program section repeats | Calling an external NC program
HEIDENHAIN | TNC 620 | Klartext Programming User's Manual | 01/2022