Clear The Sf (Ds1, Ds3) Condition; Sf-L; Clear The Sf-L Condition; Sf-P - Cisco ONS 15310-CL Troubleshooting Manual

Sonet multiservice platforms
Hide thumbs Also See for ONS 15310-CL:
Table of Contents

Advertisement

Chapter 1
Alarm Troubleshooting
Use of controls, adjustments, or performing procedures other than those specified could result in
Warning
hazardous radiation exposure. Statement 1057

Clear the SF (DS1, DS3) Condition

Complete the
Step 1
Always use the supplied electrostatic discharge wristband when working with a powered ONS 15310-CL
Caution
or ONS 15310-MA.
Step 2
If the condition does not clear, log into the Technical Support Website at
http://www.cisco.com/techsupport for more information or call Cisco TAC (1 800 553-2447).

1.7.203 SF-L

An SF Line condition applies to the line layer B2 overhead byte of the SONET signal. It can trigger a
protection switch. The SF-L condition clears when the BER level falls to one-tenth of the threshold level
that triggered the condition. A BER increase is sometimes caused by a physical fiber problem, including
a poor fiber connection, a bend in the fiber that exceeds the permitted bend radius, or a bad fiber splice.
The condition is superseded by higher-priority alarms such as
(OCN).

Clear the SF-L Condition

Complete the
Step 1
If the condition does not clear, log into the Technical Support Website at
Step 2
http://www.cisco.com/techsupport for more information or call Cisco TAC (1 800 553-2447).

1.7.204 SF-P

An SF Path condition is similar to an
layer B3 byte of the SONET overhead. It can trigger a protection switch.
The SF-P condition clears when the BER level falls to one-tenth of the threshold level that triggered the
condition. A BER increase is sometimes caused by a physical fiber problem, including a poor fiber
connection, a bend in the fiber that exceeds the permitted bend radius, or a bad fiber splice.
78-17235-01
"Clear the SD (DS1, DS3) Condition" procedure on page
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Objects: EC1, OCN
"Clear the SD-L Condition" procedure on page
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Objects: STSMON, STSTRM
"SF-L" condition on page
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-124.
1.7.135 LOF (OCN)
or
1.7.150 LOS
1-125.
1-127, but it applies to the path (STS)
1.7.203 SF-L
1-127

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ons 15310-ma

Table of Contents