Initiate A Card Or Port Lockout Command; Clear A Lock-On Or Lockout Command; Initiate An Ons 15310-Ma 1:1 Card Switch Command - Cisco ONS 15310-CL Troubleshooting Manual

Chapter 1 Alarm Troubleshooting

Initiate a Card or Port Lockout Command

For ONS 15310-MA 1:1 electrical protection groups, working or protect cards can be placed in the
Note
Lock Out state. For a 1+1 optical protection group, only the protect port can be placed in the Lock Out
state.
In node view, click the Maintenance > Protection tabs.
Step 1
In the Protection Groups list, click the protection group that contains the card you want to lock out.
Step 2
In the Selected Group list, click the card where you want to lock out traffic.
Step 3
In the Inhibit Switching area, click Lock Out.
Step 4
Click Yes in the confirmation dialog box.
Step 5
The lockout has been applied and traffic is switched to the opposite card.

Clear a Lock-On or Lockout Command

In node view, click the Maintenance > Protection tabs.
Step 1
In the Protection Groups list, click the protection group that contains the card you want to clear.
Step 2
Step 3 In the Selected Group list, click the card you want to clear.
Step 4 In the Inhibit Switching area, click Unlock.
Step 5 Click Yes in the confirmation dialog box.
The lock-on or lockout is cleared.

Initiate an ONS 15310-MA 1:1 Card Switch Command

The Switch command only works on the Active card, whether it is working or protect. It does not work
Note
on the Standby card.
In node view, click the Maintenance > Protection tabs.
Step 1
Click the protection group that contains the card you want to switch.
Step 2
Under Selected Group, click the active card.
Step 3
Next to Switch Commands, click Switch.
Step 4
The working slot should change to Working/Standby and the protect slot should change to
Protect/Active.
78-17235-01
1.10.1 Protection Switching, Lock Initiation, and Clearing
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-151