Restore The Database And Default Settings; Restore The Node Database; Pc Connectivity Troubleshooting; Windows Pc System Minimum Requirements - Cisco ONS 15310-CL Troubleshooting Manual

1.7 Restore the Database and Default Settings

d.
e.
f.
Step 6 Clear the terminal loopback circuit:
a.
b.
c.
d.
The entire circuit path has now passed its comprehensive series of loopback tests. This circuit qualifies
to carry live traffic.
1.7 Restore the Database and Default Settings
This section contains troubleshooting procedures for errors that require restoration of software data or
the default node setup.

1.7.1 Restore the Node Database

Symptom
Table 1-1
Table 1-1
Possible Problem
Incorrect or corrupted
node database.

1.8 PC Connectivity Troubleshooting

This section contains information about system minimum requirements, supported platforms, browsers,
and Java Runtime environments (JREs) for Software Release 7.0, and troubleshooting procedures for
Windows PC and network connectivity to the ONS 15310-CL or ONS 15310-MA.

1.8.1 Windows PC System Minimum Requirements

Workstations running CTC Software R7.0 for the ONS products on Windows platforms need to have the
following minimum requirements:
•
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-44
Select the appropriate state (IS; OOS,DSBLD; OOS,MT) in the Admin State column for the port
being tested.
Click Apply.
Click Yes in the confirmation dialog box.
Click the Circuits tab.
Choose the loopback circuit being tested.
Click Delete.
Click Yes in the Delete Circuits dialog box. Do not check any check boxes.
One or more nodes are not functioning properly or have incorrect data.
describes the potential cause of the symptom and the solution.
Restore the Node Database
Solution
Complete the applicable procedures in the "Maintain the Node" chapter of
the Cisco ONS 15310-CL and Cisco ONS 15310-MA Procedure Guide.
Pentium III or higher processor
Chapter 1 General Troubleshooting
78-17235-01