Trouble Notifications; Alarm Characteristics; Condition Characteristics - Cisco ONS 15310-CL Troubleshooting Manual

Sonet multiservice platforms
Hide thumbs Also See for ONS 15310-CL:
Table of Contents

Advertisement

1.5 Trouble Notifications

Table 1-8
ONS 15310-CL and ONS 15310-MA Alarm List by Logical Object as Shown in Alarm Profile (continued)
EQPT:INHSWPR (NA)
EQPT: INHSWWKG (NA)
EQPT: IOSCFGCOPY (NA)
EQPT: LO-LASERBIAS
EQPT: LO-TXPOWER
EQPT: MANRESET (NA)
EQPT: MATECLK (MN)
EQPT: MEA (CR)
EQPT: MEM-GONE (MJ)
EQPT: MEM-LOW (MN)
EQPT: NO-CONFIG (NA)
EQPT: OPEN-SLOT (NA)
EQPT: PWR-FAIL-A (MN)
EQPT: PWR-FAIL-B (MN)
EQPT: RUNCFG-SAVENEED (NA)
1.5 Trouble Notifications
The ONS 15310-CL and ONS 15310-MA systems report trouble by utilizing standard alarm and
condition characteristics, standard severities following the rules in Telcordia GR-253-CORE, and
graphical user interface (GUI) state indicators. These notifications are described in the following
sections.
The ONS 15310-CL and ONS 15310-MA use standard Telcordia categories to characterize levels of
trouble. The system reports trouble notifications as alarms and status or descriptive notifications (if
configured to do so) as conditions in the CTC Alarms window. Alarms typically signify a problem that
the user needs to remedy, such as a loss of signal. Conditions do not necessarily require troubleshooting.

1.5.1 Alarm Characteristics

The ONS 15310-CL and ONS 15310-MA use standard alarm entities to identify what is causing trouble.
All alarms stem from hardware, software, environment, or operator-originated problems whether or not
they affect service. Current alarms for the network, CTC session, node, or card are listed in the Alarms
tab. (In addition, cleared alarms are found in the History tab.)

1.5.2 Condition Characteristics

Conditions include any problem detected on an ONS 15310-CL or ONS 15310-MA shelf. They can
include standing or transient notifications. A snapshot of all current raised, standing conditions on the
network, node, or card can be retrieved in the CTC Conditions window or using TL1's set of
RTRV-COND commands. (In addition, some but not all cleared conditions are found in the History tab.)
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-14
OCN: PRC-DUPID (MJ)
OCN: RFI-L (NR)
OCN: SD-L (NA)
OCN: SF-L (NA)
OCN: SQUELCH (NA)
OCN: SQUELCHED (NA)
OCN: SSM-DUS (NA)
OCN: SSM-FAIL (MN)
OCN: SSM-OFF (NA)
OCN: SSM-PRS (NA)
OCN: SSM-RES (NA)
OCN: SSM-SDH-TN (NA)
OCN: SSM-SMC (NA)
OCN: SSM-ST3 (NA)
OCN: SSM-ST3E (NA)
Chapter 1
Alarm Troubleshooting
VT-TERM: LCAS-CRC (NA)
VT-TERM: LCAS-RX-FAIL (NA)
VT-TERM: LCAS-TX-ADD (NA)
VT-TERM: LCAS-TX-DNU (NA)
VT-TERM: LOM (MJ)
VT-TERM: LOP-V (MJ)
VT-TERM: OOU-TPT (NA)
VT-TERM: PLM-V (MJ)
VT-TERM: RFI-V (NR)
VT-TERM: SD-V (NA)
VT-TERM: SF-V (NA)
VT-TERM: SQM (MJ)
VT-TERM: TIM-V (MJ)
VT-TERM: UNEQ-V (MJ)
78-17235-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ons 15310-ma

Table of Contents