Test The Ethernet Card - Cisco ONS 15310-CL Troubleshooting Manual

Chapter 1 General Troubleshooting
Step 3 If the test set indicates a good circuit, no further testing is necessary with the facility loopback. Clear the
facility loopback:
a.
b.
c.
d.
e.
Complete the
Step 4

Test the Ethernet Card

Step 1 Complete the
replace it with a known-good one.
Removing a card that currently carries traffic on one or more ports can cause a traffic hit. To avoid this,
Caution
perform an external switch if a switch has not already occurred. Refer to the procedures in the
"1.10.1 Protection Switching, Lock Initiation, and Clearing" section on page
information, refer to the "Maintain the Node" chapter in the Cisco ONS 15310-CL and
Cisco ONS 15310-MA Procedure Guide.
Step 2 Resend test traffic on the loopback circuit with a known-good card installed.
Step 3 If the test set indicates a good circuit, the problem was probably the defective card. Return the defective
card to Cisco through the Return Materials Authorization (RMA) process. Contact Cisco Technical
Support (1 800 553-2447).
Complete the
Step 4
Clear the facility loopback:
Step 5
a.
b.
c.
d.
e.
Step 6 Complete the
page
78-17235-01
Double-click the CE100T-8 card, then click the Maintenance > Loopback tabs.
Choose None from the Loopback Type column for the port being tested.
Choose the appropriate state (IS; OOS,DSBLD; OOS,MT) from the Admin State column for the port
being tested.
Click Apply.
Click Yes in the confirmation dialog box.
"Test the Ethernet Card" procedure on page
"Physically Replace a Card" procedure on page 1-155
"Physically Replace a Card" procedure on page 1-155
Double-click the CE100T-8 card, then click the Maintenance > Loopback tabs.
Choose None from the Loopback Type column for the port being tested.
Choose the appropriate state (IS; OOS,DSBLD; OOS,MT) from the Admin State column for the port
being tested.
Click Apply.
Click Yes in the confirmation dialog box.
"1.6.2 Perform a Terminal Loopback on a Source-Node Ethernet Port" procedure on
1-30.
1.6.1 Perform a Facility Loopback on a Source-Node Ethernet Port
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-29.
for the suspected bad card and
1-148. For more
for the faulty card.
1-29