Chapter 1
Alarm Troubleshooting
1.7.250 WKSWPR
The Working Switched To Protection condition occurs when a line experiences the
on page
This condition is also raised when you use the FORCE SPAN or MANUAL SPAN command at the
network level. WKSWPR is visible on the network view Alarms, Conditions, and History tabs.
Clear the WKSWPR Condition
Complete the
Step 1
If the condition does not clear, log into the Technical Support Website at
Step 2
http://www.cisco.com/techsupport for more information or call Cisco TAC (1 800 553-2447).
1.7.251 WTR
The Wait To Restore condition occurs when the
wait-to-restore time has not expired, meaning that the active protect path cannot revert to the working
path. The condition clears when the timer expires and traffic switches back to the working path.
WTR is an informational condition. It does not require troubleshooting.
Note
1.8 DS-1 Line Alarms
The 15310-CL-CTX, DS1-28/DS3-EC1-3, and DS1-84/DS3-EC1-3 card DS1 ports provide three line
types: ESF, D4, or Unframed. The choice of framing format determines the line alarms that the card
reports.
not affect the reporting of STS alarms.
Table 1-13
Alarm
LOS
AIS
LOF
IDLE
RAI
Terminal Lpbk
78-17235-01
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Objects: EQPT, OCN, STSMON, VT-MON
1-99.
"Clear the LOS (OCN) Alarm" procedure on page
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Objects: EQPT, OCN, STSMON, VT-MON
Table 1-13
lists the line alarms reported under each format. The choice of framing format does
DS-1 Alarms by Line Type
"WKSWPR" condition on page 1-147
UNFRAMED
D4
Yes
Yes
Yes
Yes
No
Yes
No
Yes
No
Yes
Yes
Yes
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1.7.250 WKSWPR
"LOS (OCN)" alarm
1-100.
is raised and the
ESF
Yes
Yes
Yes
Yes
Yes
Yes
1-147