Cisco ONS 15310-CL Troubleshooting Manual page 299

Chapter 1 Error Messages
Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3214 Could not get number of HOs for line.
EID-3215 Error in refreshing.
EID-3216 Invalid proxy port.
EID-3217 Could not refresh stats.
EID-3218 Unable to launch automatic node setup.
EID-3219 Unable to refresh automatic node setup information.
EID-3220 Error refreshing row {0}
EID-3222 Could not clear stats.
EID-3225 Error while refreshing pane.
EID-3226 {0} termination(s) could not be deleted. {1}
EID-3227 Unable to record a baseline, performance metrics will remain
unchanged.
EID-3228 {0} termination(s) could not be created.
{1}
EID-3229 RIP is active on the LAN. Please disable RIP before enabling
OSPF.
EID-3230 OSPF is active on the LAN. Please disable OSPF before
enabling RIP.
EID-3231 Error in Set OPR
WID-3232 Cannot transition port state indirectly because the port is still
providing services: if the port state should be changed, edit it
directly via port provisioning.
EID-3233 Current loopback provisioning does not allow this state
transition.
EID-3234 Current synchronization provisioning does not allow this state
transition
EID-3235 Cannot perform requested state transition on this software
version.
EID-3236 Database Restore failed. {0}
78-17235-01
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Description
The number of High Orders (STS/STM) for
the line is not available.
Used frequently in pane classes to indicate
a general error condition when trying to
refresh from the model.
Refer to the error message text.
CTC could not refresh statistics values.
Refer to the error message text.
Failure trying to retrieve automatic node
setup information.
Error refreshing the specified row.
Refer to the error message text.
Used frequently in pane classes to indicate
a general error condition when trying to
refresh from the model.
Refer to the error message text.
CTC failed to set the baseline values while
provisioning NE. Previous values remain
unchanged.
Refer to the error message text.
Turn off the Routing Information Protocol
(RIP) on the LAN, before enabling OSPF.
Turn off the OSPF on the LAN before
enabling RIP.
An error was encountered while attempting
to provision the optical power received
(OPR).
Edit the port state while provisioning the
port.
Refer to the error message text.
You cannot transition the port state to the
target date while in the current
synchonization state.
Refer to the error message text.
CTC failed to restore the specified
database.
1-23