Cisco ONS 15310-CL Troubleshooting Manual page 288

Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
WID-2175 Extension byte mismatch.
{0}
WID-2176 Not all spans have the same OSPF Area ID. This will cause
problems with protection switching. To determine the OSPF
Area for a given span, click on the span and the OSPF Area will
be displayed in the pane to the left of the network map.
WID-2178 Only one edit pane can be opened at a time. The existing pane
will be displayed.
WID-2179 There is no update as the circuit has been deleted.
EID-2180 CTC initialization failed in step {0}.
EID-2181 This link may not be included as it originates from the
destination.
EID-2182 The value of {0} is invalid.
EID-2183 Circuit roll failure. Current version of CTC does not support
bridge and roll on a VCAT circuit.
EID-2184 Cannot enable the STP on some ports because they have been
assigned an incompatible list of VLANs. You can view the
VLAN/Spanning Tree table or reassign ethernet ports VLANs.
EID-2185 Cannot assign the VLANs on some ports because they are
incompatible with the Spanning Tree Protocol. You can view
the VLAN/Spanning Tree table or reassign VLANs.
EID-2186 Software download failed on node {0}.
EID-2187 The maximum length for the ring name that can be used is {0}.
Please try again.
EID-2188 The nodes in this ring do not support alphanumeric IDs. Please
use a ring ID between {0} and {1}.
EID-2189 TL1 keyword "all" can not be used as the ring name. Please
provide another name.
EID-2190 Adding this span will cause the ring to contain more nodes than
allowed.
EID-2191 Ring name must not be empty.
EID-2192 Cannot find a valid route for the circuit creation request.
EID-2193 Cannot find a valid route for the circuit drop creation request.
EID-2194 Cannot find a valid route for the roll creation request.
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-12
Chapter 1
Description
There is a mismatch with the extension
byte.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
CTC initialization has failed in the specified
step.
You must not include this link as it
originates from destination of a circuit. It is
against the path selection algorithm.
The value of the specified item is invalid.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
The software could not be downloaded onto
the specified node.
You must shorten the length of the ring
name.
The ring ID should not contain
alphanumeric characters, and must be in the
specified range.
Refer to the error message text.
You have reached the maximum number of
nodes allowed.
You must supply a ring name.
CTC could not complete the circuit creation
request either beacuse there are no physical
links, or the bandwidth of the available
links are already reserved.
Refer to the error message text.
Refer to the error message text.
Error Messages
78-17235-01