Dcc Connection Lost; Path In Use" Error When Creating A Circuit; Cancel The Circuit Creation And Start Over; Table 1-17 Dcc Connection Lost - Cisco ONS 15310-CL Troubleshooting Manual

1.9.12 DCC Connection Lost

1.9.12 DCC Connection Lost
Symptom
Table 1-17
Table 1-17
Possible Problem
A lost DCC connection Usually, this condition is accompanied by an EOC alarm. Clear the EOC

1.9.13 "Path in Use" Error When Creating a Circuit

Symptom
circuit creation.
Table 1-18
Table 1-18
Possible Problem
Another user has
already selected the
same source port to
create another circuit

Cancel the Circuit Creation and Start Over

Cancel the circuit creation:
Step 1
a.
b.
Step 2 Check the list of available ports. The previously selected port no longer appears in the available list
because it is now part of a provisioned circuit.
Step 3 Select a different available port and begin the circuit creation process.
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-60
The node is usually accompanied by alarms and the nodes in the network view have a gray icon.
describes the potential cause of the symptom and the solution.
DCC Connection Lost
Solution
alarm and verify the DCC connection as described in the
page
While creating a circuit, you get a "Path in Use" error that prevents you from completing the
describes the potential cause of the symptom and the solution.
"Path in Use" Error When Creating a Circuit
Solution
CTC does not remove a card or port from the available list until a circuit is
completely provisioned. If two users simultaneously select the same source
port to create a circuit, the first user to complete circuit provisioning gets use
of the port. The other user gets the "Path in Use" error.
See the
page
Click Cancel.
Click Back until you return to the initial circuit creation window.
1-49.
"Cancel the Circuit Creation and Start Over" procedure on
1-60.
Chapter 1 General Troubleshooting
"EOC" alarm on
78-17235-01