Cisco ONS 15310-CL Troubleshooting Manual page 317

Chapter 1 Error Messages
Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-6113 Cannot delete shelf, {0}
EID-6114 The maximum number of supported shelves have already been
provisioned.
EID-6115 There are bad or duplicate shelf positions.
Valid rack numbers are {0} to {1}.
Valid rack positions are {2} to {3}.
EID-6116 Attempt to access an OchTrail connection that has been
destroyed.
EID-6117 Attempt to access an OchTrail adit that has been destroyed.
WID-6118 The following slots are provisioned but do not have cards
installed:
{0}
CTC will assume they are ITU-T interfaces.
EID-6119 Unable to rearrange the shelves.
{0}
EID-6120 This equipment does not support multishelf.
WID-6121 This internal patchcord can not be provisioned because the end
points have no compatible wavelengths
EID-6122 Unable to start the wizard.
{0}
EID-6123 OSI request can not be completed successfully.
EID-6124 Invalid ALS recovery pulse interval.
EID-6125 Invalid ALS recovery pulse duration.
EID-6126 The current setting does not support the specified ALS mode.
EID-6127 All enabled routers are required to have the same area.
EID-6128 A software download is in progress. Configuration changes that
results a card reboot can not take place during software
download. Please try again after software download is done.
EID-6129 The payload configuration and card mode are incompatible.
EID-6135 DCC is present.
EID-6136 Unable to provision: {0}
78-17235-01
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Description
One or more of the equipment modules
(provisioned virtual links, provisioned
server trails, provisioned protection groups,
or provisioned DCCs) in the shelf is
currently in use. Delete cards from all the
slots and try again.
Refer to the error message text.
Refer to the error message text.
Software has prevented an attempt to access
an OCH trail .
The resource cannot be accessed because it
is released or fully utilized.
Refer to the warning message text.
One of the following conditions is present:
duplicate shelf positions, invalid shelf
positions, or concurrent movement (two
CTC sessions are attempting to rearrange
the shelves at the same time.)
Refer to the error message text.
The end points of an internal patchcord
should have compatible wavelengths.
CTC was unable to initiate the wizard due
to the specified reason.
A communication failure occurred.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
A data communication channel (DCC)
already exists.
CTC was not able to provision the specified
port or card.
1-41