Ctneqpt-Pbwork; Clear The Ctneqpt-Pbwork Alarm; Dataflt - Cisco ONS 15310-CL Troubleshooting Manual

Chapter 1 Alarm Troubleshooting
Step 11 If the alarm does not clear, complete the
for the reporting traffic card.
Step 12 If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
for more information or call Cisco TAC (1 800 553-2447) in order to report a Service-Affecting (SA)
problem.

1.7.45 CTNEQPT-PBWORK

The Interconnection Equipment Failure Working 15310-CL-CTX or CTX2500 Payload Bus alarm
indicates a failure in the main payload bus between the 15310-CL-CTX or CTX2500 and the reporting
Ethernet card. The controller card and the Ethernet or electrical card are no longer communicating.

Clear the CTNEQPT-PBWORK Alarm

If the alarm is reported against the 15310-CL-CTX or CTX2500, go to
Step 1
electrical traffic card shows the CTNEEQPT-PBWORK alarm, complete the
Ethernet or Electrical Card in CTC" procedure on page 1-154
Step 2 Verify that the reset is complete and error-free and that no new related alarms appear in CTC. A green
ACT LED indicates an active card.
Step 3 If the alarm does not clear, complete the
Always use the supplied electrostatic discharge wristband when working with a powered ONS 15310-CL
Caution
or ONS 15310-MA.
Note
If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
Step 4
for more information or call Cisco TAC (1 800 553-2447) in order to report a Service-Affecting (SA)
problem.

1.7.46 DATAFLT

The Software Data Integrity Fault alarm occurs when the 15310-CL-CTX card or CTX2500 exceeds its
flash memory capacity.
78-17235-01
Default Severity: Critical (CR), Service-Affecting (SA)
SONET Logical Object: EQPT
When you replace a card with the identical type of card, you do not need to make any changes
to the database.
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
SONET Logical Object: NE
"Physically Replace a Card" section on page 1-155
"Physically Replace a Card" procedure on page
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1.7.45 CTNEQPT-PBWORK
Step 4. If the Ethernet or
"Soft- or Hard-Reset an
for the card.
procedure
1-155.
1-43